Applicable Model

This information is for the following models:

  • SRG-120DH
  • SRG-120DS
  • SRG-120DU
  • SRG-121DH
  • SRG-201SE
  • SRG-280SHE
  • SRG-300H
  • SRG-300SE
  • SRG-301H
  • SRG-301SE
  • SRG-360SHE
  • SRG-A12


・"RM-IP Setup Tool" is a setup software for configuring Sony remote controllers and cameras that support the VISCA over IP protocol connected by LAN connection.
・The "RM-IPSetupTool.exe","ReleaseNote.txt" and "C4991001M.pdf(User's guide which include the installation procedure)" are included in the zipped download file in this page.

・The security has been enhanced.

[The required system configuration](as of December, 2017)
・CPU: Intel Core 2 Duo 2.4 GHz or higher(recommended)
・Memory: 1 GB or more (recommended)
・Hard disk: More than 50 MB free space
・OS: Microsoft Windows 7, Windows 8.1 Pro,Windows 10 Pro 32-bit or 64-bit version
・RM-IP Setup Tool may not operate correctly if you use a personal firewall or antivirus software on your computer.
In this case, disable the software.
・If you are using Windows 7, Windows 8.1, or Windows 10, disable the Windows Firewall function.
Otherwise, the RM-IP Setup Tool will not operate correctly.
・For details about configuration, please see the description for each Windows version in the user's guide.

[Preparing your system]
  ・Before use, connect the remote controllers, cameras, and a PC on which to install this software.
  ・Turn on each device in turn when performing the configuration.
  ・For details about connecting devices, refer to the operating instructions of each device.

[Downloading the Software]
  1.Download “” from the above link in this page.
  2.Uncompress the zip file, and copy “RM-IPSetupTool.exe” to any location on the PC.
  3.Double-click “RM-IPSetupTool.exe.”
  4.Connect the PC on which the software is installed to the network of the same segment as the remote controllers and cameras.
    For details about PC connection, refer to the Operating Instructions of the remote controller.
  5.Configure the network settings on the PC.
    Set the IP address and subnet mask of the PC to the same network segment as the target remote controllers and cameras to be configured.
  ・Remote controllers and cameras that are connected to a different segment than the PC cannot be configured.