Article ID : S700023626 / Last Modified : 12/07/2018

How to replace the BZ Series keyboard

    difficulty rating Difficulty rating:
    time needed Time needed:
    20 minutes activity

    !! These instructions are presented in a general way. Sony VAIO of Europe hereby informs you that the self-replacement of keyboards should be performed with care. If any damage is caused to components of your VAIO while replacing the keyboard, their repair or replacement will be considered as out of warranty and therefore chargeable. !!

    1. Shut down the computer and disconnect all peripheral devices.
    2. Unplug the computer from the AC-Adapter and remove the battery pack.
    3. Touch a grounded metal object to discharge static electricity, for example a radiator or a tap.

    4. Remove 2 screws (marked in red in Figure 1).

      Figure 1 - Removing 2 screws from the bottom

    5. Turn the unit around and open it to working position. Tilt the display back as far as it goes without applying any force.

    6. Caution:
      • The keyboard hood is attached with a number of hooks. These hooks can easily be broken, especially if force is applied in the wrong direction.
      • For reassembly, take care to fold the fingerprint sensor's cable into the space provided for it. The keyboard hood will not fit into it's place otherwise.
      To release the hooks properly, pull the center of the front edge of the keyboard hood upwards as shown in figure 2. While taking care not to damage the fingerprint sensor cable, wiggle the remaining hooks free and then place the keyboard hood bottom side up as shown in figure 2. 

      Figure 2 - Removing the keyboard hood

    7. Remove 3 screws.

      Figure 3 - Preparing to release the keyboard

    8. After you remove the screws holding the keyboard's top edge, move the keyboard a few millimeters towards the display and then fold it down to the touchpad.

      Figure 4 - Preparing to detach the keyboard from the mainboard

    9. If any tape secures the keyboard flat plastic connector to the connector, carefully peel it off.

    10. Caution:
      • If the keyboard connector is broken, the mainboard needs to be replaced. The cost of a mainboard replacement may exceed the value of a used VAIO.
      The mainboard’s keyboard connector is composed out of two parts: a fixed part (beige) and a bracket (black), which holds the keyboard's flat cable in place. Carefully unlock the bracket by pushing gently upwards at it's center as shown in figure 5.

      Figure 5 - Detaching the
      flat cable

      The flat cable should then be free and will slip out of the connector without effort.

    11. To install the new keyboard, reverse the procedure while taking note of the following:
      • To avoid unnecessary work, test if the keyboard's flat cable is well connected before continuing with the reassembly. To do so, connect the AC-Adapter to the VAIO, press first the power button and then F2 as soon as the VAIO logo is displayed to enter the BIOS. If that works, switch the VAIO off again, detach the AC-Adapter and proceed with the reassembly.
      • Take care to fold the fingerprint sensor's cable into the space provided for it. The keyboard hood will not fit into it's place otherwise.